Front & rear axle wheel bearings Front & rear drive shaft Front & rear drive shaft for AWD Front & rear wheel bearing Front & rear wheel bearings Front axle wheel bearing Front constant velocity joint halfshaft Front Constantvelocity Joint Halfshaft Front CVJ Driveshaft Front drive shaft (1.3-Liter models only) Front drive shaft (LS600h only) Front drive shaft / Rear drive shaft for AWD Front drive shaft for AWD Front half shaft Front half shaft ...

主要零部件配套厂报告  2026/09/04 更新

VinFast, Ha Tinh Plant EV VF 3 (2025年-), EV Minio Green (2025年-), EV EC Van (2025年-), EV models (计划); Vin集团工厂 ・员工人数：6,000名(1阶段)、1万5,000名(计划) ・运营初期将主要生产紧凑型城市电动车（如VF 3、Minio Green和EC Van）以及数款即将推出的车型，面向越南国内和全球市场销售。主要组件(底盘、电机、电子零部件等)从海防工厂采购，而部分车载电...

整车工厂动向  2026/09/03 更新

ator pedal module Electronic Throttle Control (gas pedal) Foot Pedal Parking Brake GFRP brake pedal Hysteresis generator for brake pedal system Lightweight plastic pedal Pedal assembly Pedal cover Pedal module Pedal module system Pedal system (interior / clutch) Pedal systems for automatic and gear models Plastic pedal Regenerative brake pedal 制动踏板 制动踏板 (出处：Automobilwoche) 制动踏板总成 制动踏板支架总成 制动...

零部件采购·配套  2026/08/21 更新

fshaft - rear - AWD CVJ system CVJ实轴 Drive shaft hub Front & rear drive shaft Front & rear drive shaft for AWD Front and rear driveshaft Front and rear sideshaft Front and rear sideshafts Front constant velocity joint halfshaft Front CVJ Driveshaft Front drive shaft Front drive shaft (1.3-Liter models only) Front drive shaft (LS600h only) Front drive shaft / Rear drive shaft for AWD Front drive shaft for AWD Front drive shaft with constant ve...

零部件采购·配套  2026/08/20 更新

d, for the vehicle with liquid fuel". - Revision of the description that  "the SOC adjustment method during testing to be consistent with GTR20. - Minor revisions of definitions to be consistency with other collision regulations, and corrections of typos . This regulation will apply to new vehicle models from September 1, 2026, but will not apply to continued production vehicles. 23 AdoptedproposalregardingUN/ECEregulation 173 00 WP.29/2024/...

法规认证  2026/08/19 更新

s (2024年-); 捷途: 大圣(Dashing) (2024年-); AMBERAUTO (AvtoTOR) : 紧凑型EV A5 (2024年-), A1 (计划); AMBERTRUCK (AvtoTOR) : Ambertruck JL (轻卡)(计划); 长安汽车(Changan) : CS75 Plus AWD (2026年-), 深蓝 (Deepal): G318 (2026年-) EONYX M2, Profi Pickup, Profi Cargo (计划); KGM Models (计划); 坦克 (Tank)：坦克300 (Tank 300) (2026年-); ROX Motors: ROX 01 (2026年-), ROX ADAMAS (2026年-计划); 铸造件，机械加...

整车工厂动向  2026/08/17 更新

：Automobilwoche) Air conditioning heater control Air heater Air heater (Airtronic M2) Air Heater [PTC] Air-heating PTC heater (4kw) Auto heater control Automatic heater control Cabin heater Cabin heater (diesel) Coolant heater Electric coolant heater Electric heater Fuel-burning heater (for Europe models) Heat pump system Heater assembly Heater blower unit development Heater control Heater control panel Heater core Heater core (heat pump) Heate...

零部件采购·配套  2026/08/10 更新

我们将携手扩展生态系统，为新计算时代奠定基础。”（摘自2025年9月15日公告） 联手Luminary Cloud与本田推出用于SUV空气动力学分析的物理AI基础模型4月9日，美国加州的可扩展工程仿真平台Luminary Cloud宣布推出其基础模型套件SHIFT Models。SHIFT-SUV初始模型是全球首个专为汽车SUV空气动力学分析而设计的物理AI（Physics AI）基础模型和数据集。 上...

主要零部件配套厂报告  2026/08/03 更新

VSoC) Fan control module Floor Mat Floor mat (through Kotobukiya Fronte) Foot parking brake Foot pedal parking brake Footwell lamp Front and rear brake pad Front brake pad Front coil spring Front disc brake rotor Front suspension member (made by tailor welded blank technology) Fuel filter (for some models) Fuel hose Fuel rail Fuel system (Fuel tank) Fuel tube Hand lever parking brake Harness HDD navigation system (CARWINGS) Headliner fabric HID h...

零部件采购·配套  2026/08/03 更新

duct Climate components Climate control unit Cooling blower fan Cooling module component CVTS flange Diesel fuel filter EGR EGR冷却器 EGR模块 EGR阀 Electronic throttle valve control motor Engine bush Engine cooling fan Engine oil cooler thermostat Front HVAC Fuel filter Fuel filter (for some models) Fuel filter module High voltage PTC heater HVAC module HVAC system HVAC控制模块 HVAC模块 HVAC鼓风电机 In-tank transmission oil coole...

主要零部件配套厂报告  2026/07/30 更新

rat Stage III Bharat Stage IV Bharat Stage V Bharat Stage VI Selected Regions All India Major Cities All India Major Cities All India All India All India Passenger Cars and LCVs 2000 Delhi,2001 MumbaiKolkata, Chennai April 2005 April 2005 April 2010(1) April 2010(1) April 2017 To be omitted All models manufactured from 1 April 2020 Note There was a delay in the full introduction, to 1 October, due to a lack of Bharat Stage III and IV comp...

法规认证  2026/07/29 更新

st Procedure) test cycles were introduced [1]. Table 8: Timetable for the Introduction of Euro 6 standards [1] Vehicle Category Date of Introduction 1 September 2014 1 September 2015 1 September 2016 Ultra-light, Small and Medium Passenger Vehicles, Small Trucks ≤ 1,305 kg GVW (Euro 6) New Models All Production - Small and Medium Trucks > 1,305 kg GVW (Euro 6) - New Models All Production Durability requirements Durability requirem...

法规认证  2026/07/29 更新

ntation date - 1 Oct 1993 & 1 Oct 1994 for all new vehicle registrations) Conformity of Production Compression Ignition Engines For N1 direct injection diesels, the HC + NOx and PM levels are higher by a factor of 1.4 until Oct 1994 (type approval) and Oct 1995 for all new vehicle registrations New Models - 1 Jul 1992; All models - 31 Dec 1992 Until 1 Jul 1994 for type approval and 31 Dec 1994 for initial entry into service of vehicles with direc...

法规认证  2026/07/29 更新

rom new vehicles and also to in-service conformity checks for categories M2, M3, N2 (excluding low-speed goods vehicles) and N3 with a design speed of over 25 km/h and vehicles of category M1 with a total mass of over 3,500 kg . The standards apply for in-service conformity checks only, for vehicle models complying with China V standards, for which designs were finalized before 1 October 2017. For new vehicles, manufacturers have to set-up their ...

法规认证  2026/07/29 更新

rds were applicable from 1 January 2010 for type approval and from one year later for all production [1] [3]. OBD is also applicable. Imports of used vehicles are banned [3]. Heavy Duty Vehicles Heavy Duty Vehicles are required to meet EU standards, applicable as follows (for type approval of new models) [1][4]. from 1 January 2007: Euro IV from 1 January 2011: Euro V from 1 January 2015: Euro V Non-road Mobile Machinery The EU Non-road Mob...

法规认证  2026/07/29 更新

er to the 2019 or 2020 model year depending upon exactly when the production of each new vehicle begins. Where production of the 2019 model year vehicle begins after the fourth anniversary of the signing of the final rule (ie after 3 March 2018), the alternative phase-in would apply for 2019.  For models beginning production before that date, the alternative phase-in would first apply for the 2020 model year. The alternative phase-ins are summa...

法规认证  2026/07/29 更新

set a later deficit or sold to another company. Any NOx emissions deficit must be settled using credits within three years.  If a deficit still applies after two years then the outstanding amount is multiplied by a factor of 1.2. In the regulations, fleet average requirements apply only to vehicle models that a company manufactures in Canada or imports into Canada.  The regulations state that for models which are sold both in the USA and Canada...

法规认证  2026/07/29 更新

rsions of the regulation. A further minor update to Normative Instruction 23/2020 was issued in July 2023 [24]. The OBD thresholds as contained in the regulation are reported in the following tables. The methodology for testing the OBD system for certification is also outlined in the documents. For models that are imported in numbers lower than 2,000 each year, the certification of the OBD system, as issued by the authorities of the EU, US or Chi...

法规认证  2026/07/29 更新

te under the jurisdiction of the Ministry of Industry and Information Technology (MIIT). Phase 1 standards are covered in Industrial Standard QC/T 924-2011 [3], these were applicable from 1 July 2012.Phase 2 standards are covered in GB 30510-2014 [18], they became effective from 1 July 2014 for new models and 1 July 2015 for all new vehicles. Phase 1 and Phase 2 fuel economy standards are detailed in the Historical Data section. Phase 3 standards...

法规认证  2026/07/29 更新

mption data is reported only on a voluntary basis.  Manufacturers report fuel economy results to the Fuel Consumption Programme (FCP) and some of the data collected is used to establish the Company Average Fuel Consumption (CAFC) figures. The Canadian GHG regulations are only applicable to vehicle models that are not also being sold in the United States. Although the Canadian GHG regulations are aligned with the EPA standards they are presented ...

法规认证  2026/07/29 更新