-Compared to an EV without a heat source that is heated only by air conditioning, the combined use of a radiant heater and air conditioning can provide the same warmth while using about 14% less energy. -The heater also features a safety design that lowers the temperature of the contact area the moment it is touched, and also lowers the heater temperature while contact is detected. -Installed in Toyota's bZ4X, RZ, and RX models.
-Used for thermal management of vehicle interior air conditioning and on-board electronic equipment such as batteries. -Installed vehicle: Toyota "bz4x"
×
Supplier Database
Integrated on-board charger and DC/DC converter unit JAPAN MOBILITY SHOW 2023 Toyota Industries Corporation
-By integrating the onboard charger and DC/DC converter into a single unit, the size and weight are 23% smaller and 17% lighter than when mounted separately. -Installed vehicle: Toyota "bz4x"
-System is comprsied of electric motors, gears, and inverter; The eAxle is developed by BluE Nexus, a joint venture between Aisin, Denso, and Toyota. -Installed vehicles: Toyota "bZ4X," Subaru "Solterra"
-System is comprised of electric motors, gears, and inverter; The eAxle is developed by BluE Nexus, a joint venture between Aisin, Denso, and Toyota. -Installed vehicles: Toyota "bZ4X," Subaru "Solterra"
×
Supplier Database
Rocker EA (enegy absorption) material 2023 JSAE Automotive Engineering Exposition Aisin Corporation (Formerly Aisin Seiki Co., Ltd.)
10 speed automatic transmission compatible with 4x2, 6x2, 8x2, 4x4, 6x4 and 8x4 configuration Linehaul: GCW/GVW up to 31/42 ton Torque up tp 1,250 Nm Vocational: GCW/GVW up to 31/42 ton Torque up tp 1,100 Nm
-High vibration resistance is achieved by a structure that supports the male terminal at three points. -Vehicles equipped: Toyota Noah and Voxy (HV), Toyota bZ4X (BEV), Mitsubishi Outlander (PHEV)
-A solution that utilizes collision analysis technology. Achieves low cost and weight reduction by increasing the strength of the material -Forming technology under development centered on high-strength cold-rolled 1470MPa material -Wheelhouse outer, rear floor side members, instrument panel reinforcement, etc. applied to Toyota bZ4X